聚酯縫編不織布經阻燃撥水加工應用於汽車內飾

文化大學機構典藏 CCUR > 理工學院 > 工學院 > 紡織工程學系 > 學報-華岡紡織期刊 > Item 987654321/45758

請使用永久網址來引用或連結此文件: https://irlib.pccu.edu.tw/handle/987654321/45758

題名:	聚酯縫編不織布經阻燃撥水加工應用於汽車內飾 The Effectiveness of Flame Retardant and Water-repellent Treatment of Knitted Non-woven Polyester Fabric in Automotive interiors
作者:	邱靖淳林永浩
貢獻者:	紡工系
關鍵詞:	聚酯縫編不織布阻燃劑撥水劑汽車內飾 Knitted Non-woven Polyester Fabric Flame Retardant Water-Repellent Automotive Interiors
日期:	2019-12
上傳時間:	2020-02-26 14:06:54 (UTC+8)
摘要:	本研究探討聚酯縫編不織布經阻燃撥水加工應用於汽車內飾之研究，本實驗使用阻燃劑濃度7%、8%、9%、10%和撥水劑濃度4%、5%、6%、7%、8%，撥水劑濃度在範圍內撥水評級均達到3級以上，而阻燃劑隨著濃度7%至10%，燃燒速率由168.7mm/min下降至79.0mm/min。水平燃燒以CNS13387制定之合格標準，燃燒速率不超過102mm/min即為合格，其撥水效果則以接觸角測試判斷與CNS10461噴灑試驗評級。 The aim of this research is to determine the effectiveness of flame retardant and water-repellent treatment of knitted non-woven polyester fabric in automotive interiors. This study tested fire retardant content ranges from 7 to 10% and water-repellent content ranges from 4 to 8%, respectively. The water repellency was classified as Grade 3 and above when 4 - 8% of water-repellent was applied. The burning rate has also decreased from 168.7 mm/min to 79.0 mm/min following 7 - 10% fire retardant treatment. The flammability test is considered pass with CNS13387 standard compliance, where the burning rate does not exceed 102mm/min. The water repellency test was determined according to contact angle assessment and CNS10461 standard spray test.
關聯:	華岡紡織工程期刊 Vol.26, No.1, 2019-12, p.52-67
顯示於類別:	[紡織工程學系] 學報-華岡紡織期刊

文件中的檔案:

檔案	描述	大小	格式	瀏覽次數
index.html		0Kb	HTML	174	檢視/開啟

檢視Licence

在CCUR中所有的資料項目都受到原著作權保護.

資料載入中.....